What does a Digitakt II SysEx message look like?
Frame layout (observed)
F0 00 20 3C 14 00 <type> 01 01 <index> <7-bit payload ...> <sum_hi> <sum_lo> <len_hi> <len_lo> F7
sum = (sum of all encoded payload bytes) & 0x3FFF -> sent as (sum>>7)&0x7F, sum&0x7F
len = (number of encoded payload bytes + 5) & 0x3FFF -> sent as (len>>7)&0x7F, len&0x7F
00 20 3C is Elektron's MIDI manufacturer ID. The byte 14 is what our Digitakt II answered with in every frame; we treat it as the device/family byte. The bytes 01 01 after the type were constant in everything we captured.
The index byte is the pattern slot for pattern+kit frames (0 = A01 … 127 = H16) and 0 for project settings.
Message types we used
- 0x50 Pattern+Kit. Decoded payload 111,616 bytes = 89,088 pattern bytes + 22,528 kit bytes.
- 0x54 Project Settings. Decoded payload 17,408 bytes. See project settings offsets.
- 0x64 request for project settings, answered with a 0x54 frame (index 0).
- 0x68 request for the working pattern+kit buffer, answered with a 0x58 frame of exactly 127,577 bytes on the wire (decodes to 111,616 bytes).
- A whole-project dump is 129 frames: 128 × 0x50 + 1 × 0x54.
A short request frame has an empty payload, so checksum 0 and length 5, for example the project-settings request:
F0 00 20 3C 14 00 64 01 01 00 00 00 00 05 F7
Practical notes
- Large replies arrive split across many USB-MIDI packets (a 0x58 reply was 2,660 packets). Reassemble until F7 before decoding.
- While such a reply is in flight, other MIDI on the same USB endpoint (including clock) can stall for 125–161 ms. See live state and telemetry.
- Always verify a write by reading the same object back and comparing decoded bytes.
FAQ
What is the Elektron SysEx manufacturer ID?
00 20 3C, right after F0.
Which message type holds a pattern and its kit on the Digitakt II?
0x50 (observed), 111,616 decoded bytes per frame.
How is the Digitakt II SysEx checksum computed?
Sum of the 7-bit-encoded payload bytes masked to 14 bits, sent as two 7-bit bytes; then a 14-bit length (encoded bytes + 5).
Observed on / Status: Observed on Digitakt II OS 1.16 and 1.17 (October–November 2026) with our own tools. Not vendor documentation; byte meanings beyond what is listed are unverified.
Deutsch
Ein DT2-SysEx-Frame besteht aus F0, Elektron-ID 00 20 3C, Gerätebyte 14, 00, Typbyte, 01 01, Index, 7-Bit-gepackter Nutzlast, 2 Byte Prüfsumme, 2 Byte Länge und F7. Typ 0x50 = Pattern+Kit, 0x54 = Projekteinstellungen. Beobachtet, nicht vom Hersteller dokumentiert.
Related
- How does Elektron's 7-bit SysEx encoding work?
- Where are pattern and Song Mode state in the Digitakt II project settings (0x54)?
- How can software read the live state of a Digitakt II (telemetry)?